Help with CPO Removal

shovelhed

Member
Joined
Apr 28, 2011
Messages
504
Reaction score
3
Location
Napa, California
I have a dedicated Mortal Kombat 2 control panel. some one covered up with another cpo. What is the best and safest way to remove without dammaging my orginal art work. I have been using just a razor blade and it is slow going maybe 1/8 done the art just flakes off in little piece's. Any Help would be appreciated.
 
That may be tough, heat would work with a heat gun but could peel both, freeze spray would hurt both, probably good ol elbow grease///
 
I had to do this on my KI control panel. I was never entirely satisfied with the end result, but at least it's complete and all intact.

I used the razor blade too. along with a lot of goo gone and I think even WD40.

all that, and a LOT of patience.

I did this a long time ago lol. I wound up nicking the CPO in a couple spots around the buttons... but like I said, it came out in one piece.
 
Thanks guys, I used citri strip and after 4 hours it just peeled right off. I will post the pics later it came awsome.
 
Back
Top Bottom