Help Royal Rumble Lights issue

shovelhed

Member
Joined
Apr 28, 2011
Messages
504
Reaction score
3
Location
Napa, California
Hey guys very new to the pin scene got my first pin last month and after stripping and cleaning my playfield down and adding new rubbers, it was time to add new lights. I ordered some Led's and regular 44's 555's and 89's.

Here is my problem none of the 89's work, even the new ones and only about half of the 44's work on the playfield and underneath the playfield. 555's all work great including the Leds. The wire braid that supplies power to the GI bulbs looks in good conditon one 44 will work on the loop and the other does not. So basically it is one on one off. Also my left sling shot does not light up at all and the right one only lights up one. Any help and directions would be great.
 
Have you put it into diagnostics and run through the lamps? I would also check the manual and the lamp matrix and see if there is any pattern to which ones work and which ones don't. Check the connector and pins on the power supply for the GI to see is there is a problem. Also check the flashers while you are in the diagnostic mode. If you are getting random bulbs on and off in the same row or column of the lamp matrix I would get a DMM and start buzzing out the wiring between sockets. Check the inside of the socket too for any corrosion.

That should be a start.
 
ok guys I fixed all the wedge based lights by flipping them, however the 89's work during test mode but most of the 44's are still out.
 
Still cant figure this out time to call a professional in. Who do you guys recommend in northern california, I am closer to San Fran than Sacramento.
 
Back
Top Bottom