Help!!! Cut Remote Board Harness On A Wells Gardner K7203

oldfandude

Active member
Joined
Apr 16, 2013
Messages
1,215
Reaction score
6
Location
Carrollton, Texas
Help!!! Cut Remote Board Harness On A Wells Gardner K7203

I have the remote board itself but someone cut off the remote board harness and it is gone. How do I find another remote board harness for a K7203?
 
Last edited:
unless you want the remote board, you can solder the pots direct to the chassis.

post a pic of what you have.

Peace
Buffett
 
I have seen them on ebay, why someone would cut this is beyond me. post a picture of what exactly is missing, I might have a spare I can send you.
 
Here is a picture of what I have.
 

Attachments

  • 20160706_062607_HDR.jpg
    20160706_062607_HDR.jpg
    187.6 KB · Views: 29
  • 20160706_062615_HDR.jpg
    20160706_062615_HDR.jpg
    196.7 KB · Views: 28
I will check to see if I have one on a junk chassis, your going to have to desolder the whole header and resolder the new one in. I can do it if you need me to.
 
Also, are all the Wells Gardner remote board harnesses from that era the same? I know the remote boards are different from model to model but I was hoping the harnesses are the same. Do any of your monitor gurus know? :)
 
unfortunately no they were not.

they changed them just enough.

you could potentially convert them but it would be more trouble than it is worth.


Peace
Buffett
 
unfortunately no they were not.

they changed them just enough.

you could potentially convert them but it would be more trouble than it is worth.


Peace
Buffett

Thanks Buffett! I plan on you eventually restoring this chassis but I was hoping to find the harness first to send with it. If I sent the remote board with it, would you be able to solder the pots directly to the chassis for use?
 
your welcome to send it on in.

that chassis unfortunately cannot do what said in an earlier post, forgot they changed it on that model.

i have a cable here for it.

Peace
Buffett
 
Back
Top Bottom