Happ Vision Pro Horz Width issue

cnlmoore

Well-known member

Donor 2023
Joined
Jan 4, 2007
Messages
5,511
Reaction score
723
Model No. SE M21-C with the little remote adjustment pcb. Mfg 1999. I can get a nice clear picture on the monitor but I can't get the entire image on screen. Top or bottom row is lost. I've tried the H adjustment on the remote, but if I scrunch it down the pixels go out of focus. I was looking for a horizontal adjustment coil, but don't see one. There are a few little pots on the monitor chassis pcb...any of those? None of them are clearly labeled.

I have tried two remote pcbs with the same results. Time to dig for a manual.

EDIT: ugh, wrong section
 
Last edited:
Look for a little white button on the chassis, then push it. See if you can adjust it after that...
 
Back
Top Bottom