Happ Vision MTG 1901

Kawydud

Member
Joined
Mar 13, 2010
Messages
970
Reaction score
10
Location
Strykersville, New York
I know this will be a simple question for most on here, but here goes. I have a Happ Vision MTG 1901 that came with a PAC MAN I recently bought. I am trying to repair the board as it only clicks like a turning signal when powered up. One of the caps is bubbled, and I will replace it. A kind member who has the same one is getting pictures of the HOT and HOV since I don't know what they look like. (Different looking than the WG pics here lately).

Anyways, I was wondering if different control boards can be connected to the tube. I removed the board and unplugged the board on the neck. It seems like it is the same as my original monitor on my Ms. Pac. Are these interchangeable? I apologize if this has been answered before, I searched under this forum but did not come up with great results.

Thanks
 
If the cap that popped is right next to the flyback, then it's possible your flyback is bad. I have two such chassis. I have a ring tester for checking flybacks and found both to be shorted internally. Unfortunately, I haven't been able to find a replacement...
 
Flyback

Thank you for the replies, I have a diagram of the board that came with the monitor, but I do not know what the flyback looks like, lack of experience. I do know that it is labeled C417 on the diagram.
 
Well, the flyback is the biggest thing on the chassis, with a couple adjustment pots built in....
 
Flyback

I see, the piece that looks like a coil from a car, has the wire going to the tube and wires going to the board plugged into the end of the tube. Thanks :)
 
Back
Top Bottom