Hantarex MTC 9110 pincushion issues

MrSinister

Well-known member

Donor 9 years: 2015-2022, 2024
Joined
Dec 30, 2008
Messages
1,785
Reaction score
114
Location
Pittsburgh, Pennsylvania
So I have a hantarex MTC 9110 that I rebuilt. It was having brightness issues. Recapped and still had issues. Found the flyback was leaking and replaced it.
Now I couldn't get the picture to go all the way to the right side of the screen. Adjusted the width coil and that issue is gone but now I have bad pincushion on both sides.
B+ is steady at 130.5v. I swapped pincushion board with no change.

I've checked the flow chart and can't figure out what would cause this.
 

Attachments

  • IMG_20170211_225219968.jpg
    IMG_20170211_225219968.jpg
    194.7 KB · Views: 13
Any ideas? Did I over adjust the width coil? Or is this an issue with one of the caps in the kit?

Also it did go into shutdown at one point yesterday. Turned off cabinet and monitor came back on......Maybe a cold solder joint somewhere I need to address?
 
Back
Top Bottom