kingofpain79
New member
Ok, so I have the monitor that I'm going to be capping for a friend, and I have a few questions about it before I work on it.
- 1st, this wire is hanging from the neckboard, location FS9. Apparently it's a ground for the dag wire. Where does it go?
- 2nd, Has anyone replaced the flyback on one of these? I can only find one at arcadecup.com, and in the description, it says Remove PP capacitor c70 when using replacement. Again, any experience here with this?
-3rd, Are these really the pain in the asses that everyone says they are? I'be almost talked myself out of taking this one on. It's currently working fine, and I want to keep it that way!
Any advice would be much appreciated. Neckboard is NE 02, Interface Board is IE 04, Deflection Board is DE 04.
- 1st, this wire is hanging from the neckboard, location FS9. Apparently it's a ground for the dag wire. Where does it go?
- 2nd, Has anyone replaced the flyback on one of these? I can only find one at arcadecup.com, and in the description, it says Remove PP capacitor c70 when using replacement. Again, any experience here with this?
-3rd, Are these really the pain in the asses that everyone says they are? I'be almost talked myself out of taking this one on. It's currently working fine, and I want to keep it that way!
Any advice would be much appreciated. Neckboard is NE 02, Interface Board is IE 04, Deflection Board is DE 04.