Hantarex 9000 neck board question

flex

Well-known member

Donor 7 years: 2019-2025
Joined
Sep 26, 2007
Messages
2,792
Reaction score
434
I have a Star Wars Trilogy game with a 28 inch Hantarex monitor. The screen only shows a vertical line. I bought another working 9000 chassis, but the neck board connection is different. It came with a neck board with a normal connector, like on a wg 4900. Mine has a wide open hole, with the pins going around the outside inner edge of the connector. I was just going to remove my connector from my neck board, and solder it to the new chassis, but I didn't want to hack it all up. The 2 different neck boards look identical, except for the connectors. Any one have any information on this??
Thanks
 
why not just swap the entire neckboard from the dead chassis to the good one??

mabye these hanatrexes are diff but on wells monitors i switch them back and fourth all the time,,,
 
Back
Top Bottom