Hand made width coils no problem. Will start making for people on request.

arcadecup

Well-known member
Joined
Oct 3, 2006
Messages
2,847
Reaction score
231
Rating - 100%
100   0   0
Hand made width coils no problem. Will start making for people on request.

I am still pushing to get width coils made for various monitor boards however that has not happened yet.

For now I will just hand wind new ones. I can get the value exact as the original not a problem. They work prefect. Here is an image attached for a hantarex polo one that I did. I just reused the same housing and ferrite core. I will call this build the Christmas coil :)
So anyone know where to get the ferrite core slugs?. I have the windings down just need the slugs as I know i will come across crumblers.
If you want one made up likely I will have you send in your original to rework.
chcoil.jpg
 
sure i would love to. is the plastic housing still intact?
 
No, that is the part that broke. It kinda looks similar to a WG4600 width coil.

Yeah, I rarely see the actual coils damaged... it seems like it's always the housing and ferrite core. Actually, every time I can think of where I've had bad coils, it's been because the housing broke and the coil was physically damaged from hanging like an opened Jack in the box.

DogP
 
Once I dig up the chassis model I'll shoot you a PM and see if you can help. Thanks!

I think new ones for WG4600 would sell good since those always break and no one sells those right now (I think?).
 
Last edited:
Back
Top Bottom