gorfchampion
New member
The bezel on my Gun Fight is near mint, except for the "shots" lettering near the bottom.
They were put on from the factory on the inside, and for whatever reason one of them was near worn off, and the other showing quite a bit of wear.
I asked prOk(Brian) if he could make new stencils for me, and he did; with a little twist.
He said he couldn't find a matching font so he took the time to cut them by hand, and they turned out absolutely sweet! 100% improvement for sure.
I used a brass glass scraper to remove the old, and just made sure I measured accurately when I put on the new.
Here's some before pics.....
Pic #1: the right side stencil looks ok from a distance, but its not...
Pic #2: what a mess
Pic #3: the right side one close up; its rough around the edges
Thanks Brian!!
They were put on from the factory on the inside, and for whatever reason one of them was near worn off, and the other showing quite a bit of wear.
I asked prOk(Brian) if he could make new stencils for me, and he did; with a little twist.
He said he couldn't find a matching font so he took the time to cut them by hand, and they turned out absolutely sweet! 100% improvement for sure.
I used a brass glass scraper to remove the old, and just made sure I measured accurately when I put on the new.
Here's some before pics.....
Pic #1: the right side stencil looks ok from a distance, but its not...
Pic #2: what a mess
Pic #3: the right side one close up; its rough around the edges
Thanks Brian!!
