mecha
Well-known member
got a very nice looking tube (what it looks like when it runs is another story I suppose) with the # R-A63ADG25X on it. it says Sharp Image on the frame. sources on The Google say it's a Zenith tube, though I don't recall seeing a Zenith label on it.
long story short, I'm looking for the mate SI chassis that goes with it.
few google searches have yielded that it's a tube that was used on the K7000, and there were Sharp Image "clones" of the K7000, SI-325, SI-327. I'm going to guess the 327 is for a 27" model.
I actually have some Sharp Image chassis that was pulled from a 27" tube that was bad and disposed of... but this one's a 25".
theoretically if a yoke swap was done, could a K7000 work with this tube?
I can get yoke readings tomorrow if needed.
long story short, I'm looking for the mate SI chassis that goes with it.
few google searches have yielded that it's a tube that was used on the K7000, and there were Sharp Image "clones" of the K7000, SI-325, SI-327. I'm going to guess the 327 is for a 27" model.
I actually have some Sharp Image chassis that was pulled from a 27" tube that was bad and disposed of... but this one's a 25".
theoretically if a yoke swap was done, could a K7000 work with this tube?
I can get yoke readings tomorrow if needed.