Gorgar - Overheating top pop bumper

clayg11

New member
Joined
Jun 14, 2011
Messages
3
Reaction score
0
Location
Mississippi
Picked up a Gorgar, had melted top pop bumper with wrong coil value. Replaced coil with proper value, also replaced MPU/Driver board with new pinballpcb. Noticed top popbumper coil still overheating, other bumpers/coils ok. Switch is not stuck. Could the switch be wired improperly? Need wiring schematic. Could power supply board cause overheating on one coil? Thanks
 
i could eyeball mine and let you know how it is wired if that would help, good luck and welcome

Well all of mine have 2 reds going to the left side(resistor silver side) and dk blue with brown on the right on top right pop , and 2 reds on left and lght blue with a red line on right on top left pop. hope this helps in some way, not sure, maybe hit it with a multi and check the valus on it and go from there
 
Last edited:
Back
Top Bottom