gorf power supply

wildwest3163

Active member
Joined
Sep 17, 2008
Messages
1,538
Reaction score
11
Location
Lake City, Florida
Ok, I got my gorf project up to the start line, got several questions. 1st off, I want to go back with the midway power supply instead of a switcher, but whoever jammatized this thing cut the plug off and Im trying to find the pinouts for the board (90411)
looking at a couple gorf pics Ive seen here the power in side looks like
1 yellow/black
2 black
3 black
4
5 white/green
6
7
8 Gray
9
10 gray
11 yellow
12 yellow

is that correct, and what are the voltages coming off the other side?

Ill add more questions as I go along, Im sure!
Thanks
 
Ok, I got my gorf project up to the start line, got several questions. 1st off, I want to go back with the midway power supply instead of a switcher, but whoever jammatized this thing cut the plug off and Im trying to find the pinouts for the board (90411)
looking at a couple gorf pics Ive seen here the power in side looks like
1 yellow/black
2 black
3 black
4
5 white/green
6
7
8 Gray
9
10 gray
11 yellow
12 yellow

is that correct, and what are the voltages coming off the other side?

Ill add more questions as I go along, Im sure!
Thanks

manual is here:

http://www.crazykong.com/manuals/Gorf.man.pdf

page 40 should answer your aforementioned questions.
 
I have a complete gorf harness I can sell you if your interested.
Pm me
 
If it makes you feel any better, that connector probably needed replaced anyways. Mine was burnt, as was the header on the p/s PCB. I had a switcher in mine for a while, but ended up doing the Bob kit on my dead p/s board and replaced the connectors and header pins.

mine:
3597287264_ca1c563cf2_b.jpg
 
Back
Top Bottom