DiscLizard
New member
I recently purchased a Golden Tee Fore! off local craigslist. The monitor did not work when I bought it, and the guy I bought it from was pretty clueless as to how the thing works in general. I know that the first thing I should do is check the power to the monitor and make sure its getting juice (got voltmeter, just haven't done this yet).
Randomly scoping craigslist I came upon a Crisis Zone Deluxe with a bad gun, wondered if I could use the HUGE projection monitor with the Golden Tee boards and hard drive (I have a pedestal built already to house the GT Fore control panel, boards hard drive and power supply)? I did some searching and found out that there were two types of Toshiba Projection monitors used in these machines, one of them has a straight 15 pin RGB connection (which I imagine would work for this application)... Its EXTREMELY cheap, guy is asking $150 for it, and EXTREMELY large, just wanted to see if anyone who has more experience might be able to shed some light on this situation for me.
Either way, I think I am going to go with a pedestal setup, but the other option is to go the CGA/EGA to VGA conversion route or get an AverKey. I have seen threads that claim that these work, but I am unsure that its the route I want to go.
Guide me KLOV'ers!
Thanks in advance!
Randomly scoping craigslist I came upon a Crisis Zone Deluxe with a bad gun, wondered if I could use the HUGE projection monitor with the Golden Tee boards and hard drive (I have a pedestal built already to house the GT Fore control panel, boards hard drive and power supply)? I did some searching and found out that there were two types of Toshiba Projection monitors used in these machines, one of them has a straight 15 pin RGB connection (which I imagine would work for this application)... Its EXTREMELY cheap, guy is asking $150 for it, and EXTREMELY large, just wanted to see if anyone who has more experience might be able to shed some light on this situation for me.
Either way, I think I am going to go with a pedestal setup, but the other option is to go the CGA/EGA to VGA conversion route or get an AverKey. I have seen threads that claim that these work, but I am unsure that its the route I want to go.
Guide me KLOV'ers!
Thanks in advance!