Museum of the Game® & International Arcade Museum® Forums

GT Fore! Complete Green PCB + HDD + Power Supply. Works great. I hate to part with it, but I have to fund a new project.
** Important note about the power supply - This was from a custom table top panel that I built, and did not have any need for the 12V wires since there were no coin doors on my build. I also tapped off the spare 5V wires to run push-button and trackball LEDs. So therefore the unused 12V power supply cables and a couple 5V were cut and capped. So if you are replacing an existing power supply and placing in a full cab, you would need to splice a few wires. Other than that, all the power wires/plugs that connect to the PCB are intact, and will run the board just fine. (The PSU could just be kept as a back-up if you don't need it).

I have included all the board power wires that connect to the power supply, and the trackball harness that goes to a Suzo/Happ trackball.

Has all the courses. (I forgot to reset the high scores, before I took the board out. Sorry).

Price is $375.00 - shipped to the Continental 48 States.

Paypal.

PM me. Thanks, Jeff

001.jpg 004.jpg 003.jpg 006.jpg 007.jpg





005.jpg 008.jpg
Back
Top Bottom