Go7 verticle hold issue

racer2e

Member
Joined
Dec 17, 2007
Messages
269
Reaction score
14
Location
Donald, Oregon
I have a go that wold not lock on verticl hold when I bought it. I did a cap kit, replaced r303, r306, r314, r317 and the hotizontal width coil. I put it back in and adjusted it and it works great until I turn it off. When I turn it back on the verticle hold is way off again. Turn the vhold adjuster all the way one way and back and it locks perfectly. Untill I turn it off again. Then it starts all over. Ideas?
Jayme
 
Bob Roberts sells a complete pot replacement kit for the G07.

Also:

Check R314 and R317. They should be 390-ohm, but some models mistakenly had 4.7k-ohm installed at the factory. If yours has 4.7k-ohm, then that is why you are having a problem, and you should replace them. Otherwise, get a new pot....
 
Back
Top Bottom