Monitor was working "ok" before I did a cap and flyback replacement. Now this is the best I can get it adjusted. The motion, I'm assuming, is the centipede moving back and forth. https://m.youtube.com/watch?v=b2Y__4ujBrQ
Strangely, turning it some suddenly snapped it into a stable picture. I had turned it slowly in both directions earlier with no clear picture. This time, I turned it some and it wasn't making much progress, and then it "snapped" into a stable picture.
Strangely, turning it some suddenly snapped it into a stable picture. I had turned it slowly in both directions earlier with no clear picture. This time, I turned it some and it wasn't making much progress, and then it "snapped" into a stable picture.
I just had the exact same thing with a G07 in my Moon Cresta. Fiddled with it a little here and there with no luck, then the picture just clicked in. Weird.
Pots replacement kit ordered. I attempted to de/resolder one of the pots, but the desolder gun I have (Hakko FR300) isn't very practical for the tabs that stick through the board. It's great for pins/wires, not so good for tabs that I can't get the nozzle to fit over.