Go7 horizontal width to wide

lostlumberjacks

Active member

Donor 2012, 2019
Joined
Oct 28, 2012
Messages
235
Reaction score
49
Location
Michigan
I have a go7 that I put a full cap kit in, new fly back, new horizontal width coil, and it's still to wide (tall) . Can't get it down enough with width coil adjustment. (vertical monitor) read something about increasing the polypropylene cap at location c515 to shrink down. It's a 534k .53 uf cap in that spot. I don't have a cap larger on hand. has anyone did this mod or have any suggestions to shrink this sucker down. Can't see the score. I know there's a lot of go7 experts on here. Any help is appreciated. Thanks Todd Scott
 

Attachments

  • IMG_5880.jpeg
    IMG_5880.jpeg
    326.6 KB · Views: 15
  • IMG_5886.jpeg
    IMG_5886.jpeg
    409.4 KB · Views: 13
Last edited:
Do ya have a 104k on hand? If so, solder that cap to the same location as your 534k to increase it to a 634k. (Parallel) I'd just solder it to the underside if I were you
 
Thanks for the help Curtislv426 I'll have to look. So a .10uf? I think one will work?
 

Attachments

  • IMG_5894.jpeg
    IMG_5894.jpeg
    332.4 KB · Views: 4
Last edited:
Back
Top Bottom