GO7 convergence question

Matt68061

Active member
Joined
May 30, 2016
Messages
344
Reaction score
26
Location
Nebraska
Good evening, kind of a rookie when it comes to tuning monitors and after an evening and a half of reading thru the forums and watching YT vids I am kind of spooked.

Have a 19 in GO7 and only the left 2 inches is a bit blurry. The rest of the picture is pretty much spot on. Before I go and possibly make things worse by fiddling with the ...does anyone have any advice for me on this? Something else I should try?

Attaching a few pics... (Hopefully they are clear enough to see what I am describing) You will notice the right side looks pretty 'in line' while the left is a bit out of whack.

Again...any advice is appreciated!

Matt

OK...can someone tell me how the hell to attach more than one pic. Using my ipad. Thx
 

Attachments

  • image.jpg
    image.jpg
    203.3 KB · Views: 30
the convergence is off in the corner and when that happens only in a corner you need to live with it or use convergence strips to correct it. someone on here was making them again but i can't remember who that was but someone should chime in that knows. g07's are common on this problem and after you spend a ton of time on this you will find yourself settling on how it is.;)
 
Arcadecup had the convergence strips at some point. I don't remember the other guy though.
 
Thanks for the quick replies! That was kind of what my local monitor guru replied to me in an email earlier. "Just live with it." I just thought one of these OCD picture guys would have a trade secret for me. Its not to bad really. Played around with it a bit more and got it pretty close.

Now ... off to google "convergence strips." :)

If anyone has anything to add I am all ears.
 
Thx again...will try to get some ordered.

Any tutorial on how to properly and safely install?
 
I doubt convergence strips will do enough to correct that, you likely need to adjust the yoke. The procedure is in the manual.
 
Back
Top Bottom