GO7 CBO 19inch 47k Ohm Resistor (R908)

OIB1981

Member
Joined
Jan 13, 2010
Messages
711
Reaction score
2
Location
West Virginia
I just re capped my GO7 CBO board the other day. I got the kit from Twisted Quarters. Didn't know I'd have to install a resistor so I just guessed at which way to put it in. I compared it to the other which didn't look the same to get idea what side goes in first. Is this right? I recolor the colors because my cell phone can't pick it up that well. Is this right?

http://img8.imageshack.us/i/photo0266colorreplace.jpg/
 
I just re capped my GO7 CBO board the other day. I got the kit from Twisted Quarters. Didn't know I'd have to install a resistor so I just guessed at which way to put it in. I compared it to the other which didn't look the same to get idea what side goes in first. Is this right? I recolor the colors because my cell phone can't pick it up that well. Is this right?

http://img8.imageshack.us/i/photo0266colorreplace.jpg/

A 19 inch resistor??
Holy cow, that's HUGE!!

A resistor is a non-polar device. It doesn't matter what direction it is installed in.
-oh- that width coil in your photo doesn't look bad at all. I would save it to replace a cracked/broken one on another chassis.
 
Honestly I think the solder points were cracked I replaced it anyhow. That's my used cap kit. I'm going to keep all this junk cause I'm a pack rat.
 
Back
Top Bottom