GO7 390 OHM resistor question

splattergatz

Well-known member
Joined
Jun 20, 2008
Messages
5,756
Reaction score
52
Location
Belton, Missouri
detected a 4.7 OHM on my GO7 chassis where there should be 390 OHM resistors, in location R314 and R317. i need to buy and install some 390 OHM resistors but how many other ones need to be replaced? do i replace ALL the 4.7's where i find them or is the factory error just on the R314 and R317?
thanks!
 
If these are the ones in the sync circuit, then only those need to be replaced...
 
R314 and R317 are supposed to be 390 ohms, 1/4 watt. The factory had mistakenly put in 4.7 k resistors in quite a few chassis before the error was caught.
 
installed 2 new resistors and it fired right up.
when i got the soldering iron down there to un-solder one of the 4.7's, it wasnt even soldered in ! how weird. little more acqainted with that section now, kinda nice.

been a little while since i seen a GO7 up close. i love it again, its so beautiful. its between that and the MTC900E, that are my right now favorites.
 
Back
Top Bottom