Gauging Interest. SW Cockpit Part Out

Todd31

New member

Donor 2011
Joined
Mar 20, 2008
Messages
1,147
Reaction score
11
Location
Cape Coral, Florida
I do not have the monitor or brown plexi in this. I believe I have everything else hardware wise. The boards work too. I will have to go through everything once more but everything should be there. This was a water damaged cab that I cut wood off of the bottom to save. I cut new wood and dow roded it in for the bottom 10 inches on the sides. I just have no interest in this anymore and since the cab had such a hard life I figured I would end its life.

What I would like to do is see if there was enough interest to move all the parts to one person. Parts would include, boards, power supply, power brick, wiring, front bezel, controller, all hardware, back glass, and coin door. That is enough for a good jump on outfitting a new cabinet.

If there is interest in this, I will spend the time to confirm what I have with my keeper cockpit and go from there. I did have the cab all the way apart at one point and put it back 80% before losing interest. The game is at my other house 3 hours away. I will be heading over there the weekend after this one so any pics could be grabbed at that time.

If there is no interest in this then I would just break it down for space and hold the parts to maybe do my own new cab project someday.

Anyway, just wanted to get some feedback on this.

Thanks,
Todd
 
The doors were in need of rebuild because they sucked up water. The sides had 10 inches of wood cut to shape, dow roded and glued in. The bottom was sprayed black and faded into the art. In an effort to save as much of the art at the time as possible, the cut was stopped short from going higher because the front art side where the new wood meets the old is flat. The back is still swollen for a few inches. The easiest thing to do will be getting some pics the weekend after next when I am in Largo so it can all make sense.

I have had a couple requests for individual parts and I don't want to go that route yet. As far as price, I was thinking $600 plus shipping. That's for everything listed in the original post. Of course if you need a part or two then this really doesn't apply to you. If someone would like to have a cabinet made for them and have almost all the parts needed (current inspection pending) then this may be interesting. Of course check and see if you can get a cabinet made and shipped.

Todd
 
I need 25" amplifone picture tube mounts too... anyone else have a set since I missed dibs on this one?
 
Back
Top Bottom