Galaga power supply wiring

Raffael

New member
Joined
Feb 10, 2018
Messages
4
Reaction score
0
Location
Georgia
I accidently pulled the power cord out of my cocktail machine and I don't know where to reconnect it. The filter for the line had previously been cut off (as seen) and the power was evidently routed to someplace else. And I'm not sure where it goes . In the pics, you can see the ends of the power cord have female connectors on them ( the blue and brn wires ) , and I do not see where these connect. Nothing is obvious to me, and I was afraid to just randomly connect them to anything. The pics should be rotated to the proper orientation but maybe can be used . I saw connections on the smaller transformer at the top and there are some on the bottom of the bigger one but the plugs will not fit under there so I figured that wasnt where it was connected. Or is there another place to connect them? Any ideas? It was working fine before this.....
 

Attachments

  • IMG_5244.jpg
    IMG_5244.jpg
    275.5 KB · Views: 57
  • IMG_5245.JPG
    IMG_5245.JPG
    500.9 KB · Views: 49
  • IMG_5251.jpg
    IMG_5251.jpg
    263.4 KB · Views: 53
Consider this an opportunity to wire it correctly, put the EMI filter back in-circuit AND add a tensioner to the main AC cord.

Wiring might be similar to this:

basic-ac.gif


Also use the Galaga manual: (page 77 for the cocktail wiring)

http://arcarc.xmission.com/PDF_Arcade_Bally_Midway/Galaga_Parts_and_Operating_Manual_(Oct_1981).pdf
 
Back
Top Bottom