G19 monitor connector question

Muffindude

Active member
Joined
Jul 8, 2010
Messages
345
Reaction score
114
Location
Richmond, BC
I recieved my wiring harness for my Centipede today, and noticed that the sync wires were different between the conversion game's (Chopper 1), and Centipede's.
I have a G19 in the game right now. Which connector do I use? Do I use the same connector as the conversion game (Bottom one), or do I use the other one? There are 2 of them on the chassis.
Thanks in advance.
 
Centipede UR is a positive sync game, and only uses the 6 pin header

There are two 6 pin connectors on the chassis.
6697751353_3c3e88b499.jpg

The bottom one is where the conversion was plugged into.
Does it matter which one I use?
Thanks.
 
There are two 6 pin connectors on the chassis.
6697751353_3c3e88b499.jpg

The bottom one is where the conversion was plugged into.
Does it matter which one I use?
Thanks.

For future reference:
Top set of headers in your pic is for Neg Comp sync
Bottom header in your pic is for Positive sync

Use the bottom 6 pin header for Centipede UR
Dok
 
Back
Top Bottom