G19-CDO Horizontal Position?

Muffindude

Active member
Joined
Jul 8, 2010
Messages
345
Reaction score
114
Location
Richmond, BC
I have a G19 monitor inside my Centipede. The picture is too high, and I wanted to adjust it, bit I couldn't find a Horizontal position pot.
I was thinking it's the H phase pot, just because I haven't seen this on other monitors, but just want to be sure before I mess something up.
Also, why is there 2 coils? I know one is for H width, but I am not sure about the other.
If anyone has a link to the manual, (which I could not find) that would be great.
Thanks in advance.
 
No manual exists for this monitor that I have found as of yet.

Yes, H phase will adjust the location on this monitor.

There are actually 3 HWC's on this strange animal.
 
So I noticed that I have to adjust the H size.
Is there a coil that I have specifically have to turn, or will any of the coils work?
Thanks.
 
I having a similar problem now. Its either I see the PacMan lives on the bottom or the high score/score area(top), or none at all (middle) from the adjustmernts I can do. My problem is that the picture is to tall on my vertical monitor. So it is the horizontal size issue. I cant reduce it in size.

Monitor is a Tempest Arcade monitor. WHatever it is.
 
I having a similar problem now. Its either I see the PacMan lives on the bottom or the high score/score area(top), or none at all (middle) from the adjustmernts I can do. My problem is that the picture is to tall on my vertical monitor. So it is the horizontal size issue. I cant reduce it in size.

Monitor is a Tempest Arcade monitor. WHatever it is.

NOT POSSIBLE, Tempest uses a WG6100 vector monitor.
 
Back
Top Bottom