G07 vertical and hoziontal issues

starfighter2

Member
Joined
Sep 22, 2009
Messages
657
Reaction score
8
Location
Derry, New Hampshire
I have a g07 that is working but the verical hold seems to be very touchy. I will hold fo a little bit an slowly start to loos the hold.

Also the hoizontal seems to be on one size and cannot get it to move to the middle.

Any thoughts
 
Yea, I have a cap kit and new flyback installed from bob roberts. I think I also put in new transitors( the round capped onses on the sides). just doug it up from puting it asied for a while.
 
Did you reflow the solder to the video connector pins?

It's not too uncommon to see flaky pots on the G07. Bob sells a full pot replacement kit...
 
I did not, but will try that tonight. I also tried to pull one of sync wires (pin6) to see if it only needed one sync and that made it much worse. So If you think the issue is caused by a sync wire, that may not be the case. Again I'll try that. The post are very old but they seem to have some effect when turning. are you thinking that if the reflow does not work that it more than likely is a pot?
 
Back
Top Bottom