Museum of the Game® & International Arcade Museum® Forums

Hi all. Just wanna run this by you fine folks. I rebuilt 2 G07s a little over a year ago. Now one was with a kit I got from Bob and one was with a kit from Ian, but I can't remember which one was done with which kit.

I followed the flow chart and get to the section where it says Open CRT heater circuit. Look for broken wires, cracked pcb or bad solder joints on HV unit (this is the flyback right?).

B+ was at 115. Adjusted to 120 and no change. If this monitor was done with the Bob kit, I'm leaning towards the flyback crapping out.

Any other thoughts?

Thanks