Picked up a cabinet with bad display today, swapped in a G07 that I had previously capped, but it has been a while since i've seen it in action.
This is what my Ms Pacman looks like - see the 1up is cut in 1/2, but you can tell by the burn (lovely burn!) that it has been wider in the past.
I think my width coil is not working properly, but what else did i screw up that the entire image isn't displaying?
thanks for any pointers!
This is what my Ms Pacman looks like - see the 1up is cut in 1/2, but you can tell by the burn (lovely burn!) that it has been wider in the past.
I think my width coil is not working properly, but what else did i screw up that the entire image isn't displaying?
thanks for any pointers!
Attachments
Last edited:
