G07 geometry problem

AMG

Member
Joined
Jan 13, 2010
Messages
193
Reaction score
1
Location
Massachusetts
I have a G07 in a Pac Man that has a trapezoidal image. The left side of the monitor as installed (bottom when looking from the chassis perspective) is wider than the other side. I was told this monitor had a recent cap kit, and it's easy to tell that the caps have been replaced at some point. The B+ is dead on at 120v. The picture is otherwise focused and clear. Could this be from bad caps or is it something else?
 
There is a pincushion transformer near the flyback. You could check that for cold solder.

And making both C517 and C518 220uF 16v caps will help, too....
 
There is a pincushion transformer near the flyback. You could check that for cold solder.

And making both C517 and C518 220uF 16v caps will help, too....

Thanks Mod. I remember the transformer you're talking about - that thing looked like it had seen some heat in its day.
 
Back
Top Bottom