G07 fbo 13" (re-titled) original flyback vs new flyback.
I have this chassis that was untested(until today), written on the side was vert. Sync problem.
I recapped it, new flyback, chassis pots, b+ filter cap, reflow, etc.
B+ is 119.1 by the way with a new flyback, so no issues there .
Anyway, it had a loud squeal, normally attributed to the h-freq pot needing adjustment, but it also had a massive loud crackling/scratchy sound running through the speakers.
Anyway, after going through this thing pretty hard, I found x305 had 2 legs smashed into each other.
Pulled it, tested good, reinstalled properly and now I have this truly fantastic picture with vibrant colors, but it isn't wide enough.
Width coil works and is adjusted all the way out. Position jumpers have been utilized.
Before I go width cap on this, could this be a sync difference between the cbo and fbo? In case it matters I have the same (lack of width) with tpg and wacko. About 1/2-3/4" on each side.
Any other insight would be encouraged and appreciated.
I have this chassis that was untested(until today), written on the side was vert. Sync problem.
I recapped it, new flyback, chassis pots, b+ filter cap, reflow, etc.
B+ is 119.1 by the way with a new flyback, so no issues there .
Anyway, it had a loud squeal, normally attributed to the h-freq pot needing adjustment, but it also had a massive loud crackling/scratchy sound running through the speakers.
Anyway, after going through this thing pretty hard, I found x305 had 2 legs smashed into each other.
Pulled it, tested good, reinstalled properly and now I have this truly fantastic picture with vibrant colors, but it isn't wide enough.
Width coil works and is adjusted all the way out. Position jumpers have been utilized.
Before I go width cap on this, could this be a sync difference between the cbo and fbo? In case it matters I have the same (lack of width) with tpg and wacko. About 1/2-3/4" on each side.
Any other insight would be encouraged and appreciated.
Last edited:
