G07-CA0 No good After Cap Kit And Flyback

Gump79

Active member
Joined
Oct 22, 2010
Messages
317
Reaction score
55
Location
Williamsville, New York
I have a G07 that is in a scramble cabinet converted to a Motorace USA. I noticed the monitor had no red in the game and someone turned the drive and adjust all the way up. I pulled it and gave it a run through on the Rejuv and the red was back. Since I had it pulled I decided to do a recap and flyback. After I did the kit to it I get a bunch of lines on the screen. I checked all my solder joints, check to make sure all the solder pads were making contact, reflowed all pin headers, and checked the H.O.T .and set B+. All are good, bad Cap Kit?? Any Ideas?
 

Attachments

  • IMG_1171[1].jpg
    IMG_1171[1].jpg
    98 KB · Views: 11
  • IMG_1169[1].jpg
    IMG_1169[1].jpg
    97.7 KB · Views: 11
I did. I can adjust them so the lines are steady but that's as good as it gets. I tried starting with everything in the middle and went from there. I also hooked it up to my robotron to make sure the sync issue wasn't with my boardset.
 
Back
Top Bottom