Please forgive my ignorance as I am completely new to this...
Have researched and read many posts on G07. I know that I have 130V coming into the monitor through the molex (which I assume to be bad). Just replaced all fuses and fuse holders on the power supply board.
Where exactly do I put my tester lead to test the B+? I see three possible points near where the board is marked "B+":
1) The leg of a pot
2) Resistor D905
3) Resistor R910
Everything "looks" good on the monitor (FlyBack - no cracks, leaking, fuses look intact, etc.). When powered up, the monitor makes the High voltage sounds (e.g. the static sound). No picture, no heater glow.
Game plays blind. This is a cocktail Ms.PM with the original G07 built in 1982.
thanks in advance!
-scott
Have researched and read many posts on G07. I know that I have 130V coming into the monitor through the molex (which I assume to be bad). Just replaced all fuses and fuse holders on the power supply board.
Where exactly do I put my tester lead to test the B+? I see three possible points near where the board is marked "B+":
1) The leg of a pot
2) Resistor D905
3) Resistor R910
Everything "looks" good on the monitor (FlyBack - no cracks, leaking, fuses look intact, etc.). When powered up, the monitor makes the High voltage sounds (e.g. the static sound). No picture, no heater glow.
Game plays blind. This is a cocktail Ms.PM with the original G07 built in 1982.
thanks in advance!
-scott
