WAGDAG
Active member
Hi,
I would like to trade an untested Hantarex Polo 25" chassis for a 19" G07 yoke and chassis.
I have a few fat neck tubes that I want to torture myself with by trying to mate successfully to a G07. I heard it's a blast.
This Polo appears to be in very good physical condition.
The good: No major damage, no burned up components, no trace damage, no PCB
scratches or missing parts. I honestly think it has never been worked on.
Everything looks factory and void of visible repair work.
The bad: Don't know if it works. Surface rust on bare metal parts indicate that it was in a
damp environment at some point. The solder side of the PCB has some water
stain type of residue on it in a few spots which came off pretty easily with a bit of
effort and my wife's toothbrush. It got warm in the 100 section near filter caps.
Please assume that this is for rebuild or parts and needs attention.
If this is lopsided request, feel free to flame on me! I gotta run...the wife is pulling in the driveway and I have to put her toothbrush back :-/
https://www.dropbox.com/s/umjv67jkvogcpnt/Polo Top.png?dl=0
https://www.dropbox.com/s/4o6zor8thbcepjc/Polo Neck Board.png?dl=0
https://www.dropbox.com/s/nbtb0472kpkb0ds/Polo Neck Back.png?dl=0
https://www.dropbox.com/s/3k8rqn3u8x5c95x/Polo Dark Spot.png?dl=0
https://www.dropbox.com/s/k2nvvq5wsmpqyrw/Polo Bottom.png?dl=0
https://www.dropbox.com/s/dx290wlp3w9k0lu/20161019_171102.jpg?dl=0
I would like to trade an untested Hantarex Polo 25" chassis for a 19" G07 yoke and chassis.
I have a few fat neck tubes that I want to torture myself with by trying to mate successfully to a G07. I heard it's a blast.
This Polo appears to be in very good physical condition.
The good: No major damage, no burned up components, no trace damage, no PCB
scratches or missing parts. I honestly think it has never been worked on.
Everything looks factory and void of visible repair work.
The bad: Don't know if it works. Surface rust on bare metal parts indicate that it was in a
damp environment at some point. The solder side of the PCB has some water
stain type of residue on it in a few spots which came off pretty easily with a bit of
effort and my wife's toothbrush. It got warm in the 100 section near filter caps.
Please assume that this is for rebuild or parts and needs attention.
If this is lopsided request, feel free to flame on me! I gotta run...the wife is pulling in the driveway and I have to put her toothbrush back :-/
https://www.dropbox.com/s/umjv67jkvogcpnt/Polo Top.png?dl=0
https://www.dropbox.com/s/4o6zor8thbcepjc/Polo Neck Board.png?dl=0
https://www.dropbox.com/s/nbtb0472kpkb0ds/Polo Neck Back.png?dl=0
https://www.dropbox.com/s/3k8rqn3u8x5c95x/Polo Dark Spot.png?dl=0
https://www.dropbox.com/s/k2nvvq5wsmpqyrw/Polo Bottom.png?dl=0
https://www.dropbox.com/s/dx290wlp3w9k0lu/20161019_171102.jpg?dl=0
