SP005
Member
Now Free: G07 Monitor in NJ
I have an Electrohome G07 CBO monitor - Tube has some burn in, main board has some cut wires going to the neck board which can be repaired. Everything was working prior to removal (needed cap kit), I just wanted to use a PC monitor in the project. I should say that everything is very dirty. I also have the original high voltage power supply / transformer. The cabinet these were removed from was a centipede cabinet in its former life and had been converted to an SF2 when I got it.
I'm not looking for much for it, if you have a bezel that would fit my cabinet (23.75"w x 23" tall) I'd be happy. The marquee on the cabinet is also an SF2, but I'm not too picky on the bezel as I've got a multi-board in it. I don't currently have anything, just a blank piece of plexiglass, so anything would be an improvement.
Pickup only, I'm in Cranford, NJ not too far from the GSP.
I have an Electrohome G07 CBO monitor - Tube has some burn in, main board has some cut wires going to the neck board which can be repaired. Everything was working prior to removal (needed cap kit), I just wanted to use a PC monitor in the project. I should say that everything is very dirty. I also have the original high voltage power supply / transformer. The cabinet these were removed from was a centipede cabinet in its former life and had been converted to an SF2 when I got it.
I'm not looking for much for it, if you have a bezel that would fit my cabinet (23.75"w x 23" tall) I'd be happy. The marquee on the cabinet is also an SF2, but I'm not too picky on the bezel as I've got a multi-board in it. I don't currently have anything, just a blank piece of plexiglass, so anything would be an improvement.
Pickup only, I'm in Cranford, NJ not too far from the GSP.
Last edited: