FS: Stern Turles, MAME Project w/ components, Rebuilt Williams PS w/ HS & more in NE

Waterborn

Active member
Joined
May 3, 2009
Messages
1,303
Reaction score
23
Location
North Myrtle Beach, Florida
Rating - 100%
22   0   0
FS: Stern Turles, MAME Project w/ components, Rebuilt Williams PS w/ HS & more in NE

I am trying to get some money together to fund a purchase, so I am selling two cabs that don't get much love around my place.

The first is the Stern Turtles cab that I picked up from a warehouse run last year. This cab came out of the same trailer that Blackdog7's Domino Man did, so it has some evidence of mice and does smell a bit. Fortunately, most of the inside is fairly clean, save for the coin door (see pics below). The exterior of the cab is in great shape. The marquee, CPO and bezel show their age. I replaced the original monitor and power cord and recapped the WG monitor that went into this cab. The game fires up and plays nicely, but there is a small black band along the top of the screen that I cannot figure out how to fix. I also replaced the width coil on the monitor, so it may need a larger width cap to allow expansion of the screen "vertically". I am asking $100 for the cab.

PC120004.jpg


PC120003.jpg


P6270037.jpg


P6270039.jpg


P6270042.jpg




The second cab is my Taito conversion MAME project. I have put a good deal of work into this one, but have kind of lost interest in getting the computer/MAME part configured and ready to play. The Kortek K-2 monitor has been recapped and a new width coil has been installed. You can see that the monitor needs some minor adjustments (and maybe a few new pots) as the right (top on the horizontal monitor) shows a minor bit of distortion. I have all the parts that are needed to make this a great MAME cab, including a brand new JAMMA harness from TRBR, a new J-pac card, a pc equipped with a new ArcadeVGA card (includes driver & manual DVD), an older spare Arcade VGA card as a backup and a JAMMA Blox board to test everything with (note: the BLOX board is a horizontally oriented game). The pc that comes with this is loaded with MAME and the MALA front end. One of the PC 3200 400Mhtz DIMM chips went bad, so you will probably need to purchase a second one to get the MAME running smoothly. Currently there is some stuttering when playing certain games. I am also throwing in some spare buttons and a spare Taito CP with trackball that I was planning to use for parts for this cab. I also have a spare AGP Graphics Card that I will throw in as well.

Currently this is what I have invested in this cab, not including time and shipping for various parts.

Cab - $75
Monitor - $50
Cap Kit & width coil - $12
Arcade VGA Card - $42
Backup Arcade VGA Card - $40
J-pac Card - $62
JAMMA Harness - $25
Computer - $50
Buttons - $23
Total = $379

Asking $300 for everything.

Finally, I also have a completely rebuilt Williams PS (for Stargate, Robotron, etc) and heat-sink. Asking $50 shipped anywhere in the US. Comes with a Williams edge connector rebuild kit from TRBR

More pics to follow
 
Back
Top Bottom