FS: Repro TRON Back Doors - $40

ataritoobin

Active member
Joined
Apr 16, 2005
Messages
1,946
Reaction score
21
Location
California
Rating - 100%
66   0   0
I have a set of NEW TRON reproduction back doors made by Rich from This Old Game. Complete with cam locks and grilles.

I also have the wooden bracket piece to attach to two separate pieces for the top door, but haven't attached it so it can be shipped flat.

A few scuffs from being stored.

$40 plus shipping.

TronDoors1.jpg

TronDoors2.jpg
 
I have a set of NEW TRON reproduction back doors made by Rich from This Old Game. Complete with cam locks and grilles.

I also have the wooden bracket piece to attach to two separate pieces for the top door, but haven't attached it so it can be shipped flat.

A few scuffs from being stored.

$40 plus shipping.

TronDoors1.jpg

TronDoors2.jpg

Wanna figure Parcel Post or ground shipping to 56303? I am interested in these doors. LMK.
 
Going to box these up and weigh/measure them in the next day or so. kmitche34 gets first dibs.
 
Who says we're not buying? I haven't heard a word from AT since I posted. I was waiting for Brett to cut me a set, but this will be quicker.

I'm not worried I can cut my own set. Just figured with all the tire kicking I would step up and grab the deal if no one else was gonna man up and do so. I actually saw this post when no one had replied yet and I assume no one had PMed. I just held off because I don't need to spend the cash. Great deal though. Not sure why no one jumped on this sooner.
 
Don't mean to hijack this thread, but has anyone figured out how to install these? I got a set (with a Tron from ZF), and I looked at it and couldn't figure out how they go on :p .

DogP
 
I also have the wooden bracket piece to attach to two separate pieces for the top door, but haven't attached it so it can be shipped flat.



TronDoors1.jpg

TronDoors2.jpg

Don't mean to hijack this thread, but has anyone figured out how to install these? I got a set (with a Tron from ZF), and I looked at it and couldn't figure out how they go on :p .

DogP

It sounds like there is a bracket not shown so hopefully you have that piece. The smaller panel with holes cut in it goes on the lowest section of the tron cab. The other two pieces (large panel with holes and smallest piece) should mount together at an angle to form one piece. Once assembled this door goes on the upper section of the tron cab. Your tron cab should have a piece of wood (crossbar) that will be just above the height of the lower back door panel. If your cab doesn't have this crossbar it might explain why you haven't been able to figure out how this mounts. Other wise I assume maybe you don't have the bracket to combine the two upper back door pieces. That would probably cause some confusion if you didn't have those.
 
Thanks... I definitely don't have the bracket for the upper doors. I'll have to find the doors and check again. I seem to remember the bottom door being too short for the bottom hole, and if I was gonna make the upper door, I think it was too tall... but that's all going from memory, so I'll check again.

DogP
 
Back
Top Bottom