FS: Qbert Power PCB and Transformer Block Cap

Phetishboy

Well-known member
Joined
Dec 12, 2006
Messages
47,929
Reaction score
9,392
Location
Avon, Minnesota
Rating - 100%
114   0   0
Both are original, tested and working. The power supply board has been partially rebuilt and has had the solder reflowed in the trouble areas. (Bob now carries the 2 big caps if you wanna replace them, he didn't when it was rebuilt) The power board is working fine. The cap is clean, tested and working. Both power connect tabs are intact and all solder/wires have been cleaned off of them. It is ready to install. I just upgraded to new parts and have no need for these. If you are restoring or building a Qbert and want to have the original parts, here you go. $45 shipped for both.

phetishboy at hotmail dot com
 
By new parts, do you mean a switcher?

My old PS is dead, I could not find the parts to rebuild it.
 
Thanks for the info. I was thinking of getting Arcade Shop's switcher. I suppose it worked out well if you are selling the OEM parts.

I think mine might have blown out the sound board and knocker when it failed. I guess there is no way to know until power is restored to them.
 
Riptor sells the power supply rebuild kit and its healthy haven't got around to it yet but will take awhile to install

Andrew

QUOTE=Robotron Jon;1304435]Thanks for the info. I was thinking of getting Arcade Shop's switcher. I suppose it worked out well if you are selling the OEM parts.

I think mine might have blown out the sound board and knocker when it failed. I guess there is no way to know until power is restored to them.[/QUOTE]
 
Never got your PM Jon, but this stuff has been sold to another KLOVer, who may or may not need it. He paid for it, but wants to wait and see if he actually needs it. If he doesn't, he will sell it to the next in line.
 
Back
Top Bottom