DPtwiz
Well-known member
- Joined
- Nov 2, 2006
- Messages
- 8,099
- Reaction score
- 621
This will be finished up today, just have to make 1 slanted piece that goes under the head, in the back. Also have to make the Amp board mounts in the head.
Game is made with black melamine and birch ply, first 2 layers of game base are birch ply. No hardware on cabinet, you'll need to drill your hinge locations for the back door, these were left blank due to no factory replacement hinges, and also will need monitor mount holes, and marqee/bezel holes drilled. Head is currently not attached for easy transport. I had planned on attaching it with Drywall screws. There is an error in this cabinet, the game sides, on the pedestal half. The back of the sides, right by the back door, the angle cut is wrong. It's supposed to be cut at 9 degrees, but there isn't such a thing as a 9 degree V router bit, it has to be custom made and very expensive, you have to buy at least 6! This is only noticable from directly behind the game, the cabinet side profile is 100% correct. It's something that's just going to happen when i make these untill i can afford 600.00 for 6 custom bits that i will only ever use on MH! Price is 500.00
Located at zip 43457 pickup greatly preferred, Paypal accepted
Game is made with black melamine and birch ply, first 2 layers of game base are birch ply. No hardware on cabinet, you'll need to drill your hinge locations for the back door, these were left blank due to no factory replacement hinges, and also will need monitor mount holes, and marqee/bezel holes drilled. Head is currently not attached for easy transport. I had planned on attaching it with Drywall screws. There is an error in this cabinet, the game sides, on the pedestal half. The back of the sides, right by the back door, the angle cut is wrong. It's supposed to be cut at 9 degrees, but there isn't such a thing as a 9 degree V router bit, it has to be custom made and very expensive, you have to buy at least 6! This is only noticable from directly behind the game, the cabinet side profile is 100% correct. It's something that's just going to happen when i make these untill i can afford 600.00 for 6 custom bits that i will only ever use on MH! Price is 500.00
Located at zip 43457 pickup greatly preferred, Paypal accepted
Last edited:
