FS: MsPac control panel

Riptor

Well-known member
Joined
Jul 10, 2007
Messages
12,078
Reaction score
144
Location
Leonartown, Maryland
Rating - 100%
299   0   0
SOLD : MsPac control panel.
Original panel blasted and powdercoated satin black. New joystick grommet, new P1/P2 microswitch pushbuttons, new overlay(namco repro), new hardware, new molex connector and pins.
SOLD
 
Last edited:
Looks really nice, did you buy a powder coat set up? My ms pac is rough I wonder what that namco would look like on mine.
 
One of the contractors from work has a huge powdercoating setup in VA. He does alot of car frames and stuff like that. I had a few control panels collecting dust so I figured I would fix up a couple to sell. Im going to be replacing the one on my mspac with a NOS panel if you think you might be interested in that.
 
Like I said my cp and marquee look like ass. lol
I have never got around to fixing them.

Sidetrack:
---
You know what I have this burgertime cp that I have almost finished stripping. It has four extra holes drilled into the panel that held an arkanoid spinner.

Who around here can weld those 4 small bolt holes shut? It seems that malice will have the BT cpo's this month. I would love to get this panel finished and ready for that new cpo.

Also have you ever seen anyone with arkanoid spinner rebuild kits? The board and pickup are fine but the bushing and knob kinda suck.
 
I dont weld, but I have some Super Pacman panels that is the same as a Burgertime. http://www.flickr.com/photos/djdns/sets/72157624416356363/

P.S. I was at Riptors place last week and his Ms Pacman panel looks very good.


Like I said my cp and marquee look like ass. lol
I have never got around to fixing them.

Sidetrack:
---
You know what I have this burgertime cp that I have almost finished stripping. It has four extra holes drilled into the panel that held an arkanoid spinner.

Who around here can weld those 4 small bolt holes shut? It seems that malice will have the BT cpo's this month. I would love to get this panel finished and ready for that new cpo.

Also have you ever seen anyone with arkanoid spinner rebuild kits? The board and pickup are fine but the bushing and knob kinda suck.
 
Back
Top Bottom