FS: Ms Pacman PCB and wiring harness

viewsonix

Member
Joined
May 7, 2009
Messages
955
Reaction score
10
Location
Virginia
Rating - 100%
15   0   0
SOLD.


Just got this today in a Pacman cabinet, it has the Fast Rom installed on it.
Played fine, but I think I want to make this cabinet a Pac Man after all.

Boards say MIDWAY PACMAN right on them so it's not a bootleg.

I will throw in the wiring harness that came with it. Apparently whoever put these in the cab soldered 2 wires from the harness to the pcb connector. Rest of the wiring goes thru connector like it should. Not sure why that was happening but it worked fine for me anyway.

I played a few games on this and it ran fine. EDIT: I have been using this the last few days, and now the cabinet is blowing fuses. I think the power supply is shot. I'll sell the pcb and harness together for $75.
Price includes shipping to Continental US.
 
Last edited:
You can make that board a pacman by removing the ribbon cable, install a Z80 on the mainboard where the ribbon cable was, then change roms 5E & 5F. MsPacs are just a modified pac board.
 
Thanks for the info, but I think at this point SWMBO has ruled that the number of cabs in my garage has exceeded capacity, so out it goes for sale....
 
I'm not sure what to charge for the harness, I figured putting them together would be easier for the next guy. Plug and play, if you will. The harness has been modified so I thought sending it with the board would be best.
 
Back
Top Bottom