FS: Lots of Atari 720 Parts

WadeLanham

Well-known member
Joined
Oct 14, 2003
Messages
7,868
Reaction score
1,617
Location
Charleston, West Virginia
Rating - 100%
12   0   0
I have a lot of 720 parts for sale. Make offers via PM or hotmail.

-No monitor or PCB's at this time... will consider later
-All metal panels with good overlays, all are yellowed. $20 each shipped
-Nice smooth and apparently no/light wear stick assembly, but with bad optics or optic PCB. Ball is scratched badly. Otherwise nice. Shaft has no rust. $80 shipped *SOLD*
-Misc metal/plastic bits. Most are gone, ask. *MOST SOLD*
-Several wiring harnesses. Two full harnesses with some burned connectors - $15 shipped
-Power bricks $20 shipped
-Coin doors $30 shipped *NEW PRICE*
-Control panel metal with new, but defective, overlay. Still looks decent. $40 shipped
-Speakers- two for $15 shipped

Wade
wadelanham at hotmail dot com
 
Last edited:
If you have a cardboard monitor bezel in good shape you can sell me I will make a small WadeLanham shrine in my garage to which I will make weekly offerings of incense and fried chicken.
 
Pic of the defective, but still presentable, CP and overlay. $40 shipped. The stick assembly is for sale separately, $40 is only the metal+overlay.

Wade
 

Attachments

  • 100_5216.jpg
    100_5216.jpg
    91 KB · Views: 44
Last edited:
Note: one of those wiring harnesses has a hacked on video board power connector, but connectors (except for the tiny cpu connector) have been repinned. I would recommend it as good, but the hack job on the wiring to the vid board connector needs to be cleaned up and soldered.
 
If he does some scans or you make a thread with exact measurements PM me, I rarely check the forum these days aside from the FS section.

I have the scan at work, but I'm not sure what DPI the scanner used. I don't have any good photo software on my work pc...

I can send you the TIF scan and you can take it from there if you want.
 
I was just going to make my own from black posterboard, wasn't planning on printing it. I really just need the angles/measurements so I can make one. Or I can try that "make your own bezel" tutorial again if it's too much trouble. I tried that once, but last time I stopped following directions halfway through and failed miserably. :eek:
 
Back
Top Bottom