retroACTIVE
Active member
When I was restoring my Gorf, the screws that hold the handle halves onto the shaft were rusty and gross... I've since replaced them with new ones, I have a few sets left.
There are 5 (10-32 x 3/8") pin-in-torx button socket cap screws needed for Gorf... I think the originals were not pin-torx but were just pin-hex... I think these would work for other bally handles too.
I have 4 sets left @ $5.00 shipped
There are 5 (10-32 x 3/8") pin-in-torx button socket cap screws needed for Gorf... I think the originals were not pin-torx but were just pin-hex... I think these would work for other bally handles too.
I have 4 sets left @ $5.00 shipped
Last edited: