FS: FH display board and WWind display assembly

louisurfer

New member
Joined
Jun 6, 2007
Messages
825
Reaction score
3
Location
Portola Hills, California
Rating - 100%
24   0   0
Funhouse display board - The entire top line on the top display was
flickering like it had a cracked solder joint. When you tapped on the
display it would come in and and out. Upon closer inspection, someone
had done a pretty ratty job of replacing the top display glass (bad
solder job, silicon to hold some stand-offs in place etc), and for the
likes of me I could not find which pin/trace was at fault. Now the
top line is just out. I lost patience with it 6 months ago, and
replaced the entire display board yesterday.

WhirlWind, entire speaker, wood, display, speaker assembly. I've had
this sitting around for a few years, The plastic has scratches done
by someone deliberately. It's useable in a pinch. One of the
displays it outgassed or not working I don't recall if it was the top
or bottom (I think the top was out).

I'm not sure what these are worth but figure the shipping will run
about $15-20. Make an offer, I'm not trying to get rich, just
recouping the cost of my new FH display and to clear up some space on
the shelf. Or just tell me these are worthless now and to chuck
em' ;)
 
Back
Top Bottom