FS: Berzerk / Frenzy ZZPUs $185

Gah!

Wasn't paying close enough attention to payments coming in.... these are SOLD out, and I'll be refunding a few people's payments.... These should be available again in January....

Thanks for the fast response!
 
Gah!

Wasn't paying close enough attention to payments coming in.... these are SOLD out, and I'll be refunding a few people's payments.... These should be available again in January....

Thanks for the fast response!

Crap! That's what I get for not checking in when I get home from work!

January for me too.

Tom
 
I have been trying to get a cable for mine for a while now, how much for just the cable shipped?

Thanks,
Dan
 
Just a quick update... I'm expecting the bare boards in next week, along with the several thousand in parts needed to build them up =-P

I hope to get a bunch built up and tested and ready to ship before the end of the month, to keep my credit card vendors happy ;)
 
Just a quick update... I'm expecting the bare boards in next week, along with the several thousand in parts needed to build them up =-P

I hope to get a bunch built up and tested and ready to ship before the end of the month, to keep my credit card vendors happy ;)

Hey Mark... are these any different from the last batch you sold? Any improvements? Not that it needed any... mine works great!
 
Hey Mark... are these any different from the last batch you sold? Any improvements? Not that it needed any... mine works great!

Replaced the 5 single resistors next to the Z80 with a SIP resistor pack, so there's slightly less soldering :)

I thought about dropping a CPLD on there to replace most of the TTL, but it wouldn't have made the board any smaller, and would have made it harder to service in the future if anything happened to it, so I left it as-is.
 
Back
Top Bottom