Museum of the Game® & International Arcade Museum® Forums

FS: Atari Lunar Lander Thrust Controller - New Reproduction from RAM Controls

This is the official release announcement for the Lunar Lander Thrust Controller.

The controller is another precision made reproduction part by RAM Controls.

The controller's frame is made from precision laser cut 11GA and 12GA 1018CR steel (much stronger than the OEM HR&P steel). The powder coat is textured black which provides a really nice finish. The black ABS cover is slightly upgraded with newer/better materials available today. The handle weldment is chrome plated (original was zinc plated) for some extra punch! The handle itself has been upgraded to aluminum with a hard black anodized finish. And to round it all off, the potentiometer has been upgraded to a top of the line "Extra Life" precision device.

The thrust controller is a drop-in replacement for the OEM controller. Just install it, hook it up and start using it!

KLOV price is $175 including shipping to any destination on the planet ($200 plus shipping on my website). If you need extra parts or parts to repair your existing thrust controller, send me a PM. I've got all the parts available! My paypal email address is [email protected]

And here's a few pics for you to enjoy.


Up-close look at the top side of a repro thrust controller.


Up-close look at the under side of a repro thrust controller.



Another up-close look at the under side of a repro thrust controller.



...just to drive the point home that I've made a boatload of these! This is a partial shot of the 60pc lot I have ready to go. It's part of the 300pc lot I've been assembling the last week or so.

Again, $175 shipped anywhere on the planet. Send to [email protected]

Enjoy!!!
Back
Top Bottom