Frogger rear panels

Zinfer

Well-known member
Joined
Apr 19, 2008
Messages
4,497
Reaction score
32
Location
Lima, Ohio
Anyone have any measurements for these two panels? When I bought this project the back panels were missing. I ran a few google searches but didn't come up with anything.
I didn't see any mention of a keylock in the manual, but I could have missed it. Looking for some measurements and pics of the Frogger rear panels if anyone has them. Thanks.
 
Thanks man. I was thinking it was just going to be a rear door until I found out there were two seperate panels. Not sure if one is keylocked and the other is just screwed in.
 
Thank you very much. I'll get to work on it right away. Thank goodness there's no notch channels to be made. I just finished with a couple DK backdoor panels.
 
I just found your frogger restoration page with a google search... HOW TIMELY, since my frogger bezel just arrived today. I also need a back door, and am following your restoration.

Can you also post the measurements of the screw holes for each piece of the back door (i.e. from top or bottom edge to screw hole centers?

And, how about the small woodgrain piece I saw in the pics at the bottom of one of the pieces - is that original, and if so, what are the measurements?

Thanks!
 
I just went 3" down and up on each corner for the upper rear panel. Not going to get anal about that. I believe originally only 4 screws were used, not 6 on the upper rear panel. As far as the blocking to hold the bottom panel in place, I just cut a piece of pressboard 12" x 2" glued and stapled in place.
 
Back
Top Bottom