Frogger coin mechs & rom chips

jimbodeanny

Well-known member
Joined
Oct 24, 2004
Messages
4,528
Reaction score
874
Rating - 100%
13   0   0
I'm looking for 2 coin mechs for a Frogger (similar to the Nintendo mechs.)

I'm also looking for the rom chips. I have a Konami style 36pin Frogger bootleg board (model HSR-2A) that currently has the "Frog" roms installed. I'm guessing a rom replacement should bring it back to its original state.
 
Last edited:
I have some new stainless steel coin mech for Forgger ,they are different than Nintendo style,$15 each shipped.
They are the similar to some kiddy ride,skill cran and Dexter coin op dryer in laundromat.
 
If you board is a copy of the original 36 pin board then you might want to buy the Frogger High score Save Kit from Braze Technologles which are sold by Arcade Shop and Mikes Arcade.
http://www.brasington.org/arcade/hs/frogger/
I think they still sell for $45.00 and are very easy to install and it only uses the Z80 CPU chip and you don't need any of your old ROM chips so by using this kit you don't need any ROMs and it saves your Hi Scores. You just need to look at this page and see if your board looks like any of the supported boards.
http://www.brasington.org/arcade/hs/frogger/boards.shtml#unsupported
I plain on putting one in my board but I have the SEGA 36 pin 834-0086 board so I know it works.
 
Yeah, I looked at that before. Mine has a 36 pin connector, just like the ones pictured, except it doesn't have one of the numbers listed. It has "HSR-2A" printed on it, but looks exactly the same as the ones pictured as "supported." I planned on installing the kit anyways so maybe I'll try that first. Thanks for the tip!
 
not the best pictures,it has stainless steel front ,same as Frogger coin mech.
 

Attachments

  • P1010195.jpg
    P1010195.jpg
    85.7 KB · Views: 11
  • P1010194.jpg
    P1010194.jpg
    82.8 KB · Views: 7
Back
Top Bottom