Focus Issue After Yoke Swap

zenomorp

Well-known member

Donor 2015
Joined
Apr 5, 2008
Messages
9,062
Reaction score
3,935
Location
Wichita, Kansas
Here's the deal. I have two 25" WG tubes. They are the same model. One is good with a bad yoke and the other is a bad tube with a good yoke. Still with me? I took the good yoke off the bad tube and installed it on the good tube to make one whole good monitor. Convergence went fine, but I can't really focus it 100%. It's focused enough, but not great. Is there a way to make it better? I have tweaked the focus pot on the flyback to optimum setting and it's not quite what I'd like it to be. The chassis is practically brand new, so it's not that. I was just wondering if maybe moving the yoke back or forward on the neck would affect the focus if the focus pot is adjusted to where it's optimum. This all make sense?
 
Back
Top Bottom