Flyback alignment - freaking holes not matching up

jehuie

Well-known member

Donor 2011
Joined
Sep 8, 2007
Messages
10,947
Reaction score
1,672
Location
Martinez, California
Ok, I got a new flyback for my k6100. I pulled the old one out and the holes are all nice and clear. But for the life of me I can't get the danged new one to fit. The pins seem close to matching up. But just ever so slightly off.

Any tips? I've done this before and it's not been this difficult.....
 
Never mind. I promised my wife certain favors if she could get it to line up. She spent a bunch of time adjusting the pins and got it in place. :) She's the best!
 
Well, the obvious way is to hold it up to the old flyback and make the spacing the same.

Sometimes I'll put the pins up to the holes on the bottom side of the chassis to make sure the spacing is right. Makes it much easier for them to go in on the top side...
 
Back
Top Bottom