Talon2000
Well-known member
Well the holidays are over, and I'm back to working on getting my Fluke 9010a hooked up to the computer, so I can send scripts.
Got the Com port settings set. but when I do the Aux/if, read, then hit enter it will reset. It's like the timeout is to short, or it's wanting a signal that it's not getting. It will also do the same reset when doing Aux/if Write ie sending a program from the Fluke to the computer.
I never even get the chance to click go on the FIDE software to transfer the script.
Any ideas?
Got the Com port settings set. but when I do the Aux/if, read, then hit enter it will reset. It's like the timeout is to short, or it's wanting a signal that it's not getting. It will also do the same reset when doing Aux/if Write ie sending a program from the Fluke to the computer.
I never even get the chance to click go on the FIDE software to transfer the script.
Any ideas?